Make sure there is no draft in the room.The knobs may be in the LIGHTING / SPARK position.Make sure there is no draft in the room.įor cooktops purchased after September 2018, the ignition spark operates continuously if a knob is held down past the child lock position. This can also be caused by air movements or gusts in the room.Whenever the flame is reignited, a clicking sound will occur (approximately every 60 seconds). When this feature is in use, the flame automatically cycles on and off. This clicking is normal and there is nothing wrong with your cooktop. The burner is using the ExtraLow ® feature.Check to make sure it is on and that the gas supply to the building is not turned off. If so, dry the igniters with a dry cotton swab and remove any lint that remains after drying. Make sure the burner ports are dry and clear clogged ports with a wire or straightened paper clip. The burner ports may be wet or clogged with food particles.If so, make sure the burner caps are properly positioned. Please call a professional installer or schedule a service visit if the regulator has not been installed properly. The arrow on the regulator should be pointing to the appliance. Check to see if the regulator supplied with the unit is installed properly. Check to see if the burner cap is properly placed and the igniter is not wet or dirty. Does the burner click when the burner knob is in the OFF position? If yes, check for the following:.Turn off the main gas supply and contact a qualified electrician to fix this. Does the burner click when the burner knob is in the ON position? If yes, you may have a wiring issue at the outlet that the appliance is connected to.Ignite the gas at full and once alight, turn it down to around 50%. The ignition will be quicker if a cooking pan is on the grate.Remove any lint that may remain after cleaning. Avoid exposing the igniters to excessive water as a damp igniter may not light up. Gently scrape the soil off with a toothpick. Carefully wipe the igniters with a cotton swab dampened with water after they have cooled down. Make sure the burners are properly positioned.Check the power supply and make sure the unit is plugged in and the circuit breaker has not tripped.The main gas supply may not be turned on.There are several solutions for this problem:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |